DAB hardware

From Opendigitalradio
Revision as of 17:09, 22 February 2015 by Hb9egm (Talk | contribs)

Jump to: navigation, search

Contents

Ettus USRP

The Ettus [1] USRP devices are used to transmit DAB signals generated by ODR-DabMod. We are mostly using the B200 model.

There are several devices on the market:

USRP B200

It is the cheapest USRP, and is probably the best choice for both experimentation and transmissions with the ODR-mmbTools. It lacks shielding, but Farnell enclosure 427-2882 fits well. Host connection: USB 2.0 or 3.0. Luckily, the native DAB sample-rate of 2048000 does not require USB 3.0 speeds.

Be wary about USB 3.0: some host controllers are not very well supported. Ettus Benchmarks

Some USRP B200 Measurements are available.

The original USRP, a.k.a. USRP1

This is the one that has been used in the beginning, before the UHD driver replaced libusrp, and is still on the market today because it's the only usrp that supports two daughterboards. While it's been used a lot, it's lack of 1PPS and 10MHz reference clock inputs, and less flexible clock generation requiring resampling on the host makes it less attractive than it's successors. They connect to the host using USB 2.0.

USRP2 and USRP N2xx

The networked series connect to the PC using 1Gbps Ethernet. They can be used successfully with ODR-DabMod through the UHD driver.

USRP B100 (product is end of life)

The successor of the USRP1. The kit with the WBX daughterboard was a perfect starting point, but it's not available anymore. The B200 is a good replacement.


USRP E1xx

Contains an embedded ARM processor that cannot be taken advantage of by the ODR-mmbTools. Call for volunteers: If you want to port ODR-DabMod to the USRP E100, doing the modulation on the ARM and the FPGA, please get in touch with us !

Daughterboards for USRP and Analog Parts

Find in this section some hardware experiment done with USRP RF front end like daughterboards or external devices (filters, power amplifiers).

The following Ettus daughterboards can be used for transmission in VHF band III:

Basic TX, RFX400 (after modification) or preferably the new WBX daughterboard.

Fighting USRP-related problems

While the USRP devices can be used for stable operation in many situations, it is sometimes tricky to find the right configuration and system settings to achieve good results. Here are some hints and remarks to increase reliability.

  • Make sure you use released versions of UHD and GNURadio, and not just the latest git checkout
  • Compile the mmbTools with the correct ./configure options
  • Monitor for USRP Underruns [2]
  • Disable all useless services on your machine
  • Disable CPU frequency scaling
  • Try different USB ports, or even USB controllers for bus-connected USRPs
  • Try to change the num_send_frame=128,send_frame_size=1024 UHD options
Personal tools